![]() ![]() Be sure to keep your stereo buss at unity, which is its optimum position! You create headroom by adjusting the levels of tracks feeding the mix buss, not by attenuating the mix buss itself. Related: What is Audio Clipping & Why Is It Important?Ī 10 dB decrease is usually more than enough to prevent clipping the mix buss/master fader.The same operation is similarly accomplished in any of the other major DAWs. In this case, the easiest solution is to grab all of the faders and turn them down! This is simply done in Pro Tools by selected the “ALL” group and pulling a fader, or in Logic Pro X by selecting all the tracks you wish to turn down and again pulling a fader. You might find yourself mixing a song with peaks every few seconds or so that clip the mix buss/master fader. And if you go in too hot, you’ll have less control later on! Avoid Clipping Individual Tracks or the Mix Buss So, you’ll always want to start recording with the faders at unity so you can accurately monitor how much headroom you’ve actually got. This would be a problem on a lead vocal, for example, where you might want to automate/ride fader levels for more control over the vocal’s dynamics. If you track a signal that’s too hot and have to pull the fader down to -20 or more, you aren’t giving yourself enough room to make incremental adjustments to the level. ![]() The actual dB adjustments you make as you pull the fader get smaller the further down the meter you get. You’ll see how the distance between -10 and +10 dB is nearly half the length of the fader, and the other half goes from -10 all the way down to infinity. These numbers represent the amount of dBs that the signal is being attenuated when you move the fader. You’ve probably noticed that there are numbered markings between the fader and the vu meter. Faders have the most resolution right in the middle, so keeping them at unity is the optimal position. ![]() When you’re recording, keep your faders at unity gain! This is the default position for almost every DAW. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |